With the popularity of the Disney movie Frozen, I think a 3D Paper Snowflake Tutorial is in order. They would make the perfect activity to do at a Frozen Themed Birthday party, or decoration to turn the party room into a frozen wonderland! I love spraying them with a little glitter spray paint after to give them some sparkle!
3D Paper Snowflake Tutorial
3D Paper Snowflake Supplies:
6 sheets of paper (normal copy paper will work fine), cut into identical size squares
STEP 1: CUT THE PAPER
You can make them in many sizes, you just have to start with a square piece of paper. For this tutorial I’ll be cutting 6 sheets of regular printer/copy paper into 8 1/2″ squares.
STEP 2: FOLD EACH PIECE
Fold each square diagonally from bottom right corner to top left corner to create a triangle. Fold corners again to make a smaller triangle. Repeat with each of the 5 remaining pieces.
STEP 3: CUT EACH PIECE
Use scissors to cut from the side with the double folds toward the single fold of the triangle. Be sure to end your cut about 1/4″ from the edge. Repeat with each of the 5 remaining pieces.
STEP 4: UNFOLD & TAPE ALTERNATING DIRECTIONS
Unfold the triangle and rotate so the uncut center line is vertical. Take the innermost cuts and bring them to the center – making a roll. Secure with a small piece of tape. Turn the paper over and roll the next paper cuts to the center in the opposite direction from the first ones and secure with a piece of tape. Last, turn the paper over again and take the remaining pieces and bring them to the center and secure with a small piece of tape. Repeat with each of the 5 remaining pieces.
STEP 5: ARRANGE & STAPLE
Lay your six pieces out into a snowflake pattern. Pinch three of the centers together and secure with a staple. Pinch the remaining three centers together and secure with a staple. Then take the two halves and staple them together. Last, add a staple to the connection point in between each section.